LCD-SPEAK
So, let’s test this code! If the display is wired up correctly, and all the timing delays are correct, then…
Discover thoughtful articles, guides and ideas about this topic.
← Explore all topicsSo, let’s test this code! If the display is wired up correctly, and all the timing delays are correct, then…
The two LEDs on the STM32 boards are pretty minimal. The docking board parallels those two LEDs (the GPIO outputs…
An HD44780-type display can perform a number of functions, but we will just focus on the two most important functions…
Remember that up to now we didn’t much care what numbers we had to feed our software delay function, as…
The two LEDs on the STM32 boards are pretty minimal. The docking board parallels those two LEDs (the GPIO outputs…
So far, we’ve done everything in this series using two LEDs and one button. I’m guessing that the thrill of…
Now it’s time to write the interrupt service routine. For the AVR, a negative edge means the button has just…
In most cases the answer is, as little as possible. An ISR should do what must be done immediately, but…
As part of the automatic response to an interrupt request, the uC hardware will save the address of the next…
That, at least, could be one reaction to this chapter. But over the years I’ve become convinced that new microcontroller…
Microprocessors and microcontrollers are widely used in embedded system products. An embedded system is controlled by its own internal microprocessor…
Chipprogrammer is a blog for introducing programming techniques for microcontroller and microprocessor which is common for academia of different countries.…